Standard Pt100 (520) class F0.3; -200 °C to +600 °C, 5.0 x 2.0 mm, 10 mm wires

Standard Pt100 (520) class F0.1; -200 °C to +600 °C, 5.0 x 2.0 mm, 10 mm wires

Pt10000 class F0.3; -200 °C to +600 °C, 5.0 x 2.0 mm, 10 mm wires, on thin substrate

Pt1000 SMD 0805 class F0.3; -50°C - +150°C; 2 x 1.2 x 0.4 mm (LxWxT); contacts lead free tinplated (96.5% Sn/3% Ag/0.5% Cu)

MiniSens Pt1000 class F0.1; -200 °C to +600 °C, 1.6 x 1.2 mm, 10 mm wires

Standard Pt1000 (232) class F0.1; -200 °C to +600 °C, 2.3 x 2.0 mm, 10 mm wires

Standard Pt1000 (520) class F0.15; -200 °C to +600 °C, 5.0 x 2.0 mm, 10 mm wires

Pt1000 class F0.3 with 3750 ppm/K; -200 °C to +600 °C, 2,3 x 2.0 mm, 10 mm wires

RealProbeTemp; -50°C - +200°C; round stainless steel housing; Ø 6 x 25 mm long; Contacts: 4x Cu/Ag stranded wire AWG 28/7; PTFE insulation; 385 mm long; 2x red; 2x white

Silicon Flow Sensor SFS01; For fast measuring of gas flow and direction; flow range from 0 to 3.5 m/s

Innovative Sensor Technology

Innovative Sensor Technology IST AG

Enhanced Product quad RS-485/RS-422 differential line drivers

Digi-Key Electronics

The LT1078 is a micropower dual op amp in 8-pin packages including the small outline surface mount package. The LT1079 is a micropower quad op amp offered in the standard 14-pin packages. Both devices are optimized for single supply operation at 5V. ±15V specifications are also provided.
Micropower performance of competing devices is achieved at the expense of seriously degrading precision, noise, speed and output drive specifications. The design effort of the LT1078/LT1079 was concentrated on reducing supply current without sacrificing other parameters. The offset voltage achieved is the lowest on any dual or quad nonchopper stabilized op amp—micropower or otherwise. Offset current, voltage and current noise, slew rate and gain bandwidth product are all two to ten times better than on previous micropower op amps.
The 1/f corner of the voltage noise spectrum is at 0.7Hz, at least three times lower than on any monolithic op amp. This results in low frequency (0.1Hz to 10Hz) noise performance which can only be found on devices with an order of magnitude higher supply current.
Both the LT1078 and LT1079 can be operated from a single supply (as low as one lithium cell or two Ni-Cad batteries). The input range goes below ground. The all-NPN output stage swings to within a few millivolts of ground while sinking current—no power consuming pull down resistors are needed.
Applications

    Battery or Solar-Powered Systems
    
        Portable Instrumentation
        Remote Sensor Amplifier
        Satellite Circuitry
    
    
    Micropower Sample-and-Hold
    Thermocouple Amplifier
    Micropower Filters

Precision Amplifiers LT1079 - Micropower, Dual and Quad, Single Supply, Precision Op Amps

SN65LBC174AMDWREP

Texas Instruments

Distributor

Distributor

SKU

Stock

Price Range

Digi-Key Electronics

296-22240-2-ND

0

2000

$10.86

Digi-Key Electronics

296-22240-6-ND

2434

1

$17.53

10

$13.93

25

$13.03

100

$12.05

250

$11.57

500

$11.29

Digi-Key Electronics

296-22240-1-ND

2434

1

$17.53

10

$13.93

25

$13.03

100

$12.05

250

$11.57

500

$11.29

Copyright © 2021 WTWH Media LLC and its licensors. All rights reserved. The material on this site may not be reproduced, distributed, transmitted, cached or otherwise used, except with the prior written permission of WTWH Media.Privacy Policy

Copyright © 2021 WTWH Media LLC and its licensors. All rights reserved. The material on this site may not be reproduced, distributed, transmitted, cached or otherwise used, except with the prior written permission of WTWH Media.

Privacy Policy