electronics module VMPA2-FB-EMS-D2-4 Diagnosis=(* Condition Monitoring, * Wire break per valve coil, * Short circuit of valves, * Undervoltage, valves), Max. number of valve positions=2, Max. number of solenoid coils=4, Intrinsic current consumption at load voltage=3 mA, Intrinsic current consumption at operating voltage=8 mA

regulator plate VMPA2-B8-R2C2-C-10 Width=21 mm, Assembly position=Any, Pneumatic vertical stacking=Pressure regulator for 2, Controller function=(* Output pressure constant, * with secondary exhaust), Pressure gauge selection=possible

multi-pin node VABE-S6-1LF-C-M1-R19 For valve terminals VTSA and VTSA-F. Assembly position=Any, Max. number of valve positions=(* 16 with monostable valves, * 8 with bistable valves), Nominal operating voltage DC=24 V, Permissible voltage fluctuation=+/- 10 %, Corrosion resistance classification CRC=0 - No corrosion stress

coupling EAMC-30-32-6.35-8 Holder diameter 1=6,35 mm, Holder diameter 2=8 mm, Size=30, Nominal length=32 mm, Assembly position=Any

coupling EAMC-30-32-8-8 Holder diameter 1=8 mm, Holder diameter 2=8 mm, Size=30, Nominal length=32 mm, Assembly position=Any

manifold block CPE14-PRS-3/8-5 For CPE valves. Grid dimension=20 mm, Assembly position=Any, Max. number of valve positions=5, Max. no. of pressure zones=2, Operating pressure=-0,9 - 10 bar

manifold block CPE18-PRS-3/8-3 For CPE valves. Grid dimension=26 mm, Assembly position=Any, Max. number of valve positions=3, Max. no. of pressure zones=2, Operating pressure=-0,9 - 10 bar

proximity sensor SME-8M-DS-24V-K-0,3-M8D Electric, with reed contact, for drives with T-slot, assembly from above, with M8 plug. Authorisation=(* RCM Mark, * c UL us - Listed (OL)), CE mark (see declaration of conformity)=to EU directive for EMC, Special characteristics=Oil resistant, Materials note=(* Free of copper and PTFE, * Conforms to RoHS), Measuring principle=Reed magnetic

proximity sensor SME-8M-DS-24V-K-7,5-OE Electric, with reed contact, for drives with T-slot, assembly from above, with cable. Authorisation=(* RCM Mark, * c UL us - Listed (OL)), CE mark (see declaration of conformity)=to EU directive for EMC, Special characteristics=Oil resistant, Materials note=(* Free of copper and PTFE, * Conforms to RoHS), Measuring principle=Reed magnetic

mini slide DGSL-4-30-P1A For position sensing, with highly accurate, durable ball-cage guide and very high repetition accuracy, flexible damping on both sides with metallic end position (P1). Stroke=30 mm, Adjustable endposition range/front length=25,5 mm, Adjustable endposition range/rear length=13,5 mm, Piston diameter=6 mm, Operating mode of drive unit=Yoke

Festo

Automotive Connectors ASM CONN 3 F GT 280 BLACK

Mouser Electronics

The LT1078 is a micropower dual op amp in 8-pin packages including the small outline surface mount package. The LT1079 is a micropower quad op amp offered in the standard 14-pin packages. Both devices are optimized for single supply operation at 5V. ±15V specifications are also provided.
Micropower performance of competing devices is achieved at the expense of seriously degrading precision, noise, speed and output drive specifications. The design effort of the LT1078/LT1079 was concentrated on reducing supply current without sacrificing other parameters. The offset voltage achieved is the lowest on any dual or quad nonchopper stabilized op amp—micropower or otherwise. Offset current, voltage and current noise, slew rate and gain bandwidth product are all two to ten times better than on previous micropower op amps.
The 1/f corner of the voltage noise spectrum is at 0.7Hz, at least three times lower than on any monolithic op amp. This results in low frequency (0.1Hz to 10Hz) noise performance which can only be found on devices with an order of magnitude higher supply current.
Both the LT1078 and LT1079 can be operated from a single supply (as low as one lithium cell or two Ni-Cad batteries). The input range goes below ground. The all-NPN output stage swings to within a few millivolts of ground while sinking current—no power consuming pull down resistors are needed.
Applications

    Battery or Solar-Powered Systems
    
        Portable Instrumentation
        Remote Sensor Amplifier
        Satellite Circuitry
    
    
    Micropower Sample-and-Hold
    Thermocouple Amplifier
    Micropower Filters

Precision Amplifiers LT1079 - Micropower, Dual and Quad, Single Supply, Precision Op Amps

15326877

Aptiv

Distributor

Distributor

SKU

Stock

Price Range

Mouser Electronics

829-15326877

0

1

$1.74

25

$1.36

50

$1.11

100

$0.974

Copyright © 2021 WTWH Media LLC and its licensors. All rights reserved. The material on this site may not be reproduced, distributed, transmitted, cached or otherwise used, except with the prior written permission of WTWH Media.

Privacy Policy

15326877

Aptiv

Distributor

Distributor

SKU

Stock

Price Range

Mouser Electronics

829-15326877

0

1

$1.74

25

$1.36

50

$1.11

100

$0.974

Copyright © 2021 WTWH Media LLC and its licensors. All rights reserved. The material on this site may not be reproduced, distributed, transmitted, cached or otherwise used, except with the prior written permission of WTWH Media.Privacy Policy

Copyright © 2021 WTWH Media LLC and its licensors. All rights reserved. The material on this site may not be reproduced, distributed, transmitted, cached or otherwise used, except with the prior written permission of WTWH Media.

Privacy Policy